Features:
Applications:
RSPD-03BD180-4955
1.25Gb/s 180km LC BiDi SFP Transceiver
Hot Pluggable, Single LC, +3.3V, 1490nm Tx/1550nm Rx, DFB-LD&APD, Single-mode, DDM
Description:
FIBERWDM RSPD-03BD180-4955 Transceivers are a high performance, cost effective module which have a single LC optics interface. They are compatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA) and Digital diagnostics functions are available via the 2-wire serial bus specified in SFF-8472.The receiver section uses a PIN receiver and the transmitter uses a 1490 nm DFB laser, more than 40dB link budge ensure this module 1000Base-ZX Ethernet 180km application.
Absolute Maximum Ratings
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Storage Temperature |
TS |
-40 |
|
+85 |
°C |
Supply Voltage |
VCC |
-0.5 |
|
4 |
V |
Relative Humidity |
RH |
0 |
|
85 |
% |
Recommended Operating Environment:
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Case operating Temperature |
TC |
0 |
|
+70 |
°C |
Supply Voltage |
VCC |
3.1 |
|
3.6 |
V |
Supply Current |
Icc |
|
|
300 |
mA |
Inrush Current |
Isurge |
|
|
Icc+30 |
mA |
Power dissipation |
Pmax |
|
|
1.5 |
W |
Electrical Characteristics TOP=(TOP=-30 to70°C, VCC = 3.1 to 3.6 Volts)
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Note |
Transmitter Section: |
|
|||||
Input differential impedance |
Rin |
90 |
100 |
110 |
|
|
Single ended data input swing |
Vin PP |
250 |
|
1200 |
mVp-p |
|
Transmit Disable Voltage |
VD |
Vcc – 1.3 |
|
Vcc |
V |
2 |
Transmit Enable Voltage |
VEN |
Vee |
|
Vee+ 0.8 |
V |
|
Transmit Disable Assert Time |
Tdessert |
|
|
10 |
us |
|
Receiver Section: |
|
|||||
Single ended data output swing |
Vout,pp |
300 |
|
800 |
mv |
3 |
LOS Fault |
Vlos fault |
Vcc – 0.5 |
|
VCC_host |
V |
5 |
LOS Normal |
Vlos norm |
Vee |
|
Vee+0.5 |
V |
5 |
Power Supply Rejection |
PSR |
100 |
|
|
mVpp |
6 |
Note:
1. AC coupled.
2. Or open circuit.
3. Into 100 ohm differential termination.
4. 20 – 80 %
5. LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6. All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5MHz up to specified value applied through the power supply filtering network shown on page 23 of the Small Form-factor Pluggable (SFP) Transceiver Multi-Source Agreement (MSA), September 14, 2000.
Pin Assignment
Diagram of Host Board Connector Block Pin Numbers and Names
Recommended Circuit
SFP Host Recommended Circuit
Mechanical Dimensions
Mechanical Drawing
想知道这个产品吗?
如果您对我们的产品感兴趣并想了解更多详细信息,请在此处留言,我们将尽快答复您。